This post is continuing on the story of my newly purchased Springfield Armory TRP Operator 10mm Longslide. I’m going to touch on three topics – the initial mags, ammo and my first trip to the range.

The Magazines

The pistol comes with two 8-round magazines that flush fit with the bottom of the grip. My experience with factory mags is mixed so I bought four Wilson Combat 47NX magazines to use as well plus they hold 9 rounds and have a bumper on the bottom.

I tried a factory magazine with one of the S&B 180gr FMJ rounds I bought and it immediately jammed on the first test, and the second and the third. Okay, I really wasn’t surprised given past poor experiences and tried one of the Wilsons. The round went right in. I thought that fixed the problem and we’ll come back to that later when we discuss the range.

The Ammunition

With my Rock Ultra and Bruin, S&B 180 grain FMJ proved to be a very decent range ammo so I bought a few hundred rounds of it to break in the TRP.

In the 10mm community, Underwood has a great reputation and I had also used it with both of my previous 10mms. This time though, I bought 5 boxes of 220gr hard cast for bears and 4 boxes of 200gr XTP to try out.

The hardcast comes in at 220 grains and the bullet is a “Hi-Tek Coated Hard Cast Flat Nose” and the Brinell Hardness Number (BHN) is 41. That puts it somewhere between copper at 35 BHN and Hardened 6060 Aluminum at 75BHN. Pure lead comes is at 5 BHN. In short, you’d expect it to penetrate without mushrooming easily – which is what I would want for a bear’s skull for example. The round pushing the bullet 1200 FPS and 703 ft/lbs at the muzzle makes sure it gets delivered hard.

The 200 grain XTP was what the vendor had in stock at the time. I like XTP bullets in general as they perform well in terms of mushrooming so this is not something I would use on a bear but two legged predators maybe. Underwood reports that the muzzle velocity is 1,250 FPS with 694 ft/lbs.

The S&B 180 grain FMJ is for the range. In the past I found it affordable, reliable and accurate enough for practice. S&B USA reports that it’s exiting the muzzle at 1,165 FPS with 544 ft/lbs of energy.

A Quick Cleaning and Lubrication

I ran a couple of 10mm RamRodz down the bore to clean out the accumulated gunk from the factory and travel. I then applied Superlube to the frame rails and other lubrication points on the pistol.

The First Range Experience

The weather was perfect for going to the range and both Niko and I commented that as we lugged firearms, ammo, targets and what have you down the shooting lane we planned to use.

First up for testing was the TRP operator. We loaded the Wilson Combat mags up with the S&B ammo, loaded the first round, fired and it jammed. Well crud. It was jamming hard too – the bullet was hitting the top of the chamber during feeding but not rotating enough to then go the rest of the way forward. After a few of these we noticed that the transition point between the feed ramp and the chamber was actually indenting the brass enough to cause a notch and stop the round hard. So much for the S&B at that point.

We then switched to the hard cast and the TRP relatively liked that. It fired a lot more with fewer jams. What we noticed was that the angle on the hard cast bullet seemed to be such that it helped the round to properly chamber most of the time. So, we shot about 20 rounds in total and decided to move on to the 200gr HP.

Wow – the Underwood 200gr XTP load was jam city. I could not get them to feed at all. So, disappointed, we stopped shooting the TRP and put it away. In looking at the cases, I was betting that I needed to slightly bevel the transition point and polish both the ramp and chamber. Doing that will be the topic of our next post — and yes, it did make a world of difference.

---

If you find this post useful, please share the link on Facebook, with your friends, etc. Your support is much appreciated and if you have any feedback, please email me at in**@ro*********.com. Please note that for links to other websites, I may be paid via an affiliate program such as Avantlink, Impact, Amazon and eBay.

---

---

A few months ago while hiking in the Smokies, we got up close and personal with some black bears including a sow with cubs. Neither encounter was planned of course. We were about half to three fourths of the way back to the parking area from Laurel Falls and it was near dusk when my daughter rounded the bend of the trail and shouted out “bear”. Not what I was expecting.

I went to the front of the line and saw a juvenile just as startled as we were about 50 feet ahead. I had drawn my 9mm SIG P365 that was loaded with Critical Duty +P ammo but also knew it was woefully under-powered and was literally praying that I would not need it even though Critical Duty is supposed to have some degree of barrier penetration. I was telling the bear firmly to go away and we made a bunch of noise. The bear really had a “oh crap it’s humans look on its face”, immediately looked for an exit in the brush and left the trail. No drama at all. I think the foliage and all the turns in the trail had muffled the noise of our six person group. As we left the area I kept checking behind us just to be sure it wasn’t following us.

You can’t make this stuff up – we had hiked Laurel Falls during the day so many times and never seen bears. However, 10 minutes later we saw two cubs in a tree maybe 25 yards off the trail and down a slope and the sow was at the bottom looking at us. What worried me was that she stood up and walked parallel making sure we were not a threat. We stayed as far away as we could on the trail and I was talking to the bear as we all walked down the trail. She made sure we were leaving and watched until she sat down and started eating berries. When she did that, I knew we were okay and we walked the remaining 15-or-so minutes to the parking lot.

Okay, I did a lot wrong in hindsight. We did not think we would encounter bears on this trail that we’d walked many times before without seeing anything and then we had two encounters. Walking at dusk likely played a role. I didn’t have my bear spray with me and a 9mm would not be my first choice of a backup pistol. We were lucky in that the bears were genuinely not interested in us at all. These things went through my head as we went back to the hotel that night and during our drive home.

Thinking About What To Carry Next Time

When we go back, we will be carrying bear spray – no ifs, ands or buts. Bear spray works 90+% of the time to deter a bear and there is research to support it. Also, a bear can cover a ton of ground astonishingly fast. I read 44 feet in 2-3 seconds and that also means you aren’t going to have a ton of time plus you may have a moving target to try and hit. A fog of pepper spray deployed in front of the bear is a good first line of defense … but what if the next bear is part of the 10% that doesn’t stop?

The more I thought about it, the more I wish I had not sold my 10mm Dan Wesson Bruin. At the time, I needed the money more than I did the pistol even though it was amazing. I’d read plenty about guys carrying 10s in bear country with heavy hard cast loads for penetration of a bear’s skull — by the way, you shoot for the head because all the layers of fat, muscle and bone in a big bear are liable to work against you.

After a lot of thinking, I decided to get another 10mm along with some stout loads with hard cast bullets before our next trip. My good friend Scott Igert of Michigan Gun Exchange has long told me how impressed he is with the Springfield Armory TRP Operator pistols. As a retired police officer with tons of firearms experience, I put a lot of faith in his opinion. I told him my story and he recommended the 10mm TRP Operator.

Enter The TRP Operator

Scott and I both like 1911 style pistols and how they feel. My one quirk is that I like long slides so I told him to order me the 6″ version. I like how the longer pistols feel and also how they absorb some of the recoil. The downside is that finding holsters usually requires custom work and I knew that up front.

After waiting about a week, Scott messaged me that the PC9610L18 TRP Operator Longslide had arrived. Needless to say, I went right over to get it.

The TRP operators are just wicked. The slide and frame are forged steel and sport a massive forged stainless steel match bull barrel with a 1:16 twist. It’s a “fully supported” barrel in that the feed rap is part of the barrel and no part of the cartridge case is left dangling once chambered. It also has a small notch at the rear to let you see if there is a round in the chamber.

The sights are adjustable and use tritium for illumination. They work very well.

The pistol weighs 45 oz (2.81 pounds) empty with a nice balance. It’s 9.6″ long overall and about 5.5″ tall. The grip angle really works for me and feels way better to me than a Glock’s angle. The one thing I didn’t care for were the grip panels. SA puts these “VZ Alien G10” grips on the pistols and they are very nicely done. It just so happens that I really prefer rubber Hogue grips on my 1911s so that is a personal preference thing.

All in all, it was a functional piece of art. It did feel gritty and dry but I tend to expect that with most firearms these days.

Summary

This gives you and overview of the pistol. In the next post I will talk about the ammo and magazines.

2/16/2021 Update: Read this post where I list the Q&A between readers and myself about the TRP.

---

If you find this post useful, please share the link on Facebook, with your friends, etc. Your support is much appreciated and if you have any feedback, please email me at in**@ro*********.com. Please note that for links to other websites, I may be paid via an affiliate program such as Avantlink, Impact, Amazon and eBay.

---

---