Hi folks, I am just trying to get the word out there that we actually have OEMP164015B compatible magazines that the 10mm and 40mm high cap 2011-style RIA pistols use in stock.
The base magazine I used to create these mags are the very well made Mec-Gar magazines for the Para P-16 (mag model MGP164015B). In addition to being close in terms of the required tube design, the Mec-Gar mags are quality and feature:
- heat treated tubes
- high tensile music wire springs
- the follower is made from high impact nylon and locks the slide open
These mags were all converted by me and then hand fit and tuned to my RIA 52009 high cap 10mm pistol. For most shooters they should be good to go. If there is a feed problem then a minor adjustment of the feed lips (perhaps opening them a tad so the round sits higher) should be all that is required.
To accommodate the flared mag well that RIA put on these pistols, I used a variety of lengths of Dawson Precision base plates. The +100 Dawson model pretty much is flush with the bottom of the flared mag well, the +200 sits just a bit lower and the +300 is lower still. The number refers to the length (0.100, 0.200 and 0.300 inches).
Our prices start at $69.99 and go down (not up) the more you buy. I just saw some of these magazines listed for the first on GunBroker this morning and they start at $80 and go up!
Click here for the section of our online store where these magazines are at.
Click here if you would like to open my blog post about how the magazines were converted.
If you find this post useful, please share the link on Facebook, with your friends, etc. Your support is much appreciated and if you have any feedback, please email me at in**@ro*********.com. Please note that for links to other websites, I may be paid via an affiliate program such as Avantlink, Impact, Amazon and eBay.
