Another great accessory for the Yugo M92 or M85 PAP is the slick picatinny rail kit that CNC Warrior sells. This thing is a breeze to install and is the best means I have seen for adding an optic to the M92. Because the screws are inserted from the rail side, it is superior to other products that require the screws to come in from underneath the dust cover and risk being hit by the bolt carrier.
All you need is the pistol, a drill and some cutting oil to do the installation.
SAFETY STEP – MAKE SURE THE WEAPON IS UNLOADED. NEVER ASSUME THAT IT IS – VERIFY IT IS UNLOADED BEFORE YOU BEGIN WORK.
1. This is the top thick hinge of the M85/M92 dust cover. See the faint circles? Those are the spot welds and they are very hard! Do not drill into them! The new CNC Warrior mount has four holes and you only need to use two of them. The reason there is four is so you can pick the best two that get you around/away from the spot welds. Please note that my rail is only silver because it was a brand new design and they hadn’t applied a finish yet. If you order one, you will get a black rail!
2. Here you can see my fancy high tech tools. My Ryobi drill, Tap Magic cutting oil to lubricate the drills and the taps. Note, you will need to buy a tap handle if you do not have one. Do not take the short cut of trying to start the tap with a regular socket or open end wrench. You really want the tap to be firmly held so you can tap the threads at a right angle to the surface of the hinge. Also, see that little black cylinder? That is a drill guide that you put into the hole you select to guide the drill bit to the right place on the hinge. Be sure to use the cutting oil!
3. As an aside, I blasted the mount and then sprayed on flat black Molyresin and baked it. You’d never know it came to me unfinished.
By the way, pictured above is a cheap Harbor Freight air brush. I used to buy a bunch of them at a time and then throw them away when they hard problems. I now use a Paasche H series air brush and am much happier with it.
4. After you clean up the chips and are ready to do the final screwing of the mount, be sure to apply Blue Loctite so it does not come loose.
That’s it! The mount is solid and it holds my Vortex Sparc red dot just great. Note our quick takedown pin to make it easy to remove the cover and get the optic out of the way.
10/27/18 Note: Vortex discontinued the Sparc red dot. They sell a great 2 MOA red dot called the Crossfire that I really like.
If you find this post useful, please share the link on Facebook, with your friends, etc. Your support is much appreciated and if you have any feedback, please email me at in**@ro*********.com. Please note that for links to other websites, I may be paid via an affiliate program such as Avantlink, Impact, Amazon and eBay.