Tag Archives: coated

I Found Some Surprisingly Good Coated Carbide End Mills On Amazon

Hi folks, I’ve been doing plunge cuts on Mec-Gar magazine tubes to remove an indent they have to limit rounds. Mec-Gar magzines are high quality and the tubes are hardened high carbon steel. I dulled two uncoated carbide bits that I had bought from either MSC or McMaster before I decided I better try something else.

A quick safety note: For readers unfamiliar with machining, this is an end mill meant to be used in a millling machine in this case. Carbide is interesting in that it is very wear resistant but it is also very brittle. Because of this, the workpiece you are cutting must be very rigidly held in place or the vibrations will tear up the mill and potentially send pieces of carbide flying at you. So, #1 – wear safety glasses. #2 – only do this type of work with a mill. #3 – to be explicit, I would not recommend doing this in a drill press. End of safety brief .

I suspected part of my problem was the heat being generated and adding cutting fluid made for a messy clean up that took longer than I wanted. This made me start researching coated carbide end mills and they get pricey fast.

I decided to check out Amazon because it was a Friday night and I really needed to get some center cutting end mills in ASAP to keep producing magazines.

I ran across a listing a listing for “Speed Tiger ISE Carbide Square End Mills” and started reading. It has an Aluminum Titanium Boron Nitride (AlTiBn) coating that they claimed improved wear resistance and provided better heat resistance as well. Given the number of good reviews they had,I ordered in three to give them a try.

Well, guess what? I am still using my first end mill after 60+ plunge cuts into approximately 18 gauge hardened hgh carbon sheet metal with no lubricant. Make all the jokes you want about dry cutting but it is saving me a bunch of clean up time.

I plan to keep using the first bit and still have two in reserve. Given the very deceent price to performance ratio,I thought I would pass along the report. The following has links to a number of Speed Tiger’s products:

I hope this helps you out.


Note, I have to buy all of my parts – nothing here was paid for by sponsors, etc. I do make a small amount if you click on an ad and buy something but that is it. You’re getting my real opinion on stuff.

If you find this post useful, please share the link on Facebook, with your friends, etc. Your support is much appreciated and if you have any feedback, please email me at info@roninsgrips.com. Please note that for links to other websites, I may be paid via an affiliate program such as Avantlink, Impact, Amazon and eBay.