When you are working in the shop, it is frequently very important to have reliable measurements. I have owned a number of calipers and one good dial micrometer (which I can’t find) over the years. I am definitely not a machinist but I run into situations regularly where I need more reliable measurements then what a normal pair of digital calipers can give. I don’t know if you’ve noticed but it is really easy to get readings all over the place on a caliper depending on how hard you squeeze it. At any rate, I realize I really should invest in a digital micrometer but had a limited budget also I started doing a bunch of research and found the IGaging 0-1″ micrometer at Amazon. I bought it back in January 2017 and have been very happy. Everything about it is very easy to use. This is exactly what I have and you can click on the link to learn more and order one:
4/10/2017 Testing:
After I posted the blog, some guys asked me to take a feeler gauge, get some samples and post the results. I must admit I know I should take 30 samples but opted just to do 10 for the sake of time. I zeroed the micrometer and pulled out the .027″ blade and I have no idea where the set came from – quite possibly Autozone or Harbor Freight so just how exact it is, I don’t know. I would take a measurement, back the anvil off a few turns, and bring it in again until I could hear the clutch click. The work and the micrometer were resting on the table at all times unlike the photo I took above. Here is the results that I generated in Excel:
I think it is remarkable that out of 10 scores there was only a spread of 0.00015″ – that repeatability is pretty cool given the price of this micrometer and is exactly why I wanted a micrometer vs. a caliper for some of the stuff I do.
What I like:
- Very easy to use with simple instructions
- Large easy to read digits
- You can adjust a little clutch to get consistent clamping during measurements
- The battery is easy to get to
- Appears to take consistent measures
- As you can see from testing, repeatability appears to fall very close to their 0.0001″ claim
- If we assume that the gauge really is .027, then the average (.026895) is exactly .000105 short of that but that is an assumption
- Easy to toggle between inches and millimeters, which I have to do all the time
Con:
- One small complaint is a very cheap case. Now, I’d rather have the money spent on the tool so this is a nit-picking con but also the only one I have so far.
If you’re looking for a good budget 0-1″micrometer that does not break the bank, I would recommend you buy it.
7/19/2019 Update: Still going strong. No problems to report.
If you find this post useful, please share the link on Facebook, with your friends, etc. Your support is much appreciated and if you have any feedback, please email me at in**@ro*********.com . Please note that for links to other websites, I may be paid via an affiliate program such as Avantlink, Impact, Amazon and eBay.