The first thing I noticed with the Glock 29 with its stock 10 round magazine was that the grip was way too small for my hands. Granted I wear XL sized gloves and have big palms courtesy of my dad and grandpa but literally, my pinky finger had nothing to grab on to and I really didn’t want to control a 10mm pistol running hot loads with just two fingers – excluding my trigger finger that is. I had a trick up my sleeve though – I knew I could get grip extensions that would make holding the pistol way more comfortable.
The solution comes from Pearce – they make a really nice injection molded base plate replacement that gives us just enough of an extension to comfortably hold the pistol. Since Pearce released their’s some knock offs have come out that look identical but I stick with Pearce.
How To Install Them
There’s two reasons for this post – first is to tell you that there is a grip extension for the 10 round magazines and the second is to give you a tip on installing them that will save you some real grief and this pertains to Glock mags in general.
On most magazines, you push the locking button down that holds the baseplate in position and while you are doing that, you then push the baseplate off while capturing the floor plate and spring so they don’t come flying out. Trust me, those suckers can come out like a rocket.
A Glock is close but not quite. Everything I said above is true but there is also a ridge case in the middle of the magazine’s rails that the base place slides on that makes it an absolute bear to do without a Glock magazine tool. Honestly, the first time I went to disassemble a Glock magazine I could not get it off and then started searching – people said to get the tool. I thought the tools were a scam because I never needed one before other than something to push a recessed dimple down or pry off a base plate with 30-50 years of junk on it. Well, with a Glock magazine, you really need the tool and everybody and there brother makes them or imports cheap knock offs that work as well.
When you look at the tool. it has a nose that pushes the dimple down on the floor plate while also allowing you to have enough leverage to then pry the base plate off thanks to the mechanical leverage it gives you.
Again, be prepared to grab/capture the floor plate and spring assembly or they will rocket out. Yeah, I’m making light of this but a lot of people have suffered eye injuries from not being prepare and getting hit by the parts as they fly out.
If you have big hands or just want to make the grip a tad taller for whatever reason, I absolutely recommend the Pearce Grip Extensions and have four of them on my OEM Glock 10 round magazines. I have shot a ton of hot Underwood and Buffalo Bore ammo and had no problem controlling the pistol. So far, they have held up just fine.
Note, I have to buy all of my parts – nothing here was paid for by sponsors, etc. I do make a small amount if you click on an ad and buy something but that is it. You’re getting my real opinion on stuff.
If you find this post useful, please share the link on Facebook, with your friends, etc. Your support is much appreciated and if you have any feedback, please email me at email@example.com. Please note that for links to other websites, I may be paid via an affiliate program such as Avantlink, Impact, Amazon and eBay.